This only started happening a few days ago but my printer comes on and offline about every other minute. You cannot send files to it however via the slicer I just get error 400.
The network diagnostics on the printer seem fine (very high signal and like 2-3 ms ping to dns – 165 ms ping to prusa connect), and I can ping the printer with no packet loss on the lan. It is connected to wifi, but I have an access point in the workshop room it lives in.
I know the camera doesn't use anything on the printer but its on the same AP and streams realtime video with no issues.
I did update the printers firmware but that doesn't seem to help – version 6.10.3+16400
There is a qidi plus 4 on the same ap/net and it works perfectly fine. I'm reasonably sure the wifi ap is fine.
I have found a bunch of bugs (most are dupes) on github that have this exact scenario, but they all say the issue was fixed in 6.4.x: [BFW-7098] [BUG] Prusa XL goes offline when left in the menus · Issue #4581 · prusa3d/Prusa-Firmware-Buddy
Anyone run into this and managed to solve it? (I know there's a rule about only asking for help in the megathread but I can't find it anywhere.
Source: r/prusa3d · by /u/Angelworks42